Axle Alignment Test Requirements
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi A5 Quattro, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Follow the general information regarding vehicle alignment. Refer to AXLE ALIGNMENT INFORMATION .
- Before driving the vehicle onto the alignment rack, make sure there is enough space between the vehicle and the setting device. Distance between the setting device and the vehicle: 120 cm ± 2.5 cm.
- If there is not enough space, drive the vehicle backward on the alignment rack to be able to use the space.
- Vehicle must be cool.
- Check suspension, steering and steering linkage for excessive play and damage, repair if necessary.
- Tread depth difference may be no more than 2 mm on an axle.
- Prescribed tire pressure
- Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
- The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
- The alignment rack and wheel alignment computer can deviate from their original calibration over time; therefore, they should be calibrated at least once a year during maintenance.
- Handle highly sensitive units with care.
- If necessary, contact the manufacturer for instruction on the proper use of the equipment.