Coolant Pump, Removing And Installing: Removing

Depending on the model, preliminary work may be required. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

Toothed Belt Guard, Version 1: 

Fig 1: Oil Pressure Switch, Level 3 -F447- Installation Position -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Remove the bolts -arrows- and remove the toothed belt guard.

Toothed Belt Guard, Version 2: 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Free up the wiring harness -3-.

-- Remove the bolts -arrows- and remove the toothed belt guard -1-.

Continuation: 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

-- Remove the toothed belt from the coolant pump.