Side Spoiler, Removing And Installing: Installing
Install in reverse order of removal and note the following:
-- Check the foam seal -4- for damage.
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Fold back the ends of the protective film, or attach a pulling aid to the protective film -3-.
-- Align the spoiler -6- with an alignment pin -2- on the rear lid -1-.
-- Remove the protective film from the pulling aids and from the adhesive tape -5-.
-- Push on the spoiler until it engages audibly on the rear lid.
-- Push the entire length of the spoiler on using the :3356 .
- Vehicle resting time is at least one hour at room temperature.
- It is durable after at least 24 hours.