Sill Panel Trim, Removing And Installing: Installing
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.
Installation preparation for reinstalling the sill panel trims:
-- Remove any adhesive residue completely from the trim.
-- Clean the adhesive surface on the plastic side using the Cleaning Solution:D 009 401 04 .
-- Apply the Plastic Primer:D 366 PR1A1 to the adhesive surface on the cover and let it dry.
-- Apply double-sided tape to the same location on the trim. Refer to the parts information
Continuation:
-- Clean the adhesive surface on the paint side using the Cleaning Solution:D 009 401 04 .
-- Apply Bonding Agent:D 355 205A2 to the adhesive surface on the paint side using the Applicator:D 009 500 25 and let it dry.
-- Remove the protective film from the adhesive tape -1 and 3-.
-- Position the sill panel trim -2- over the pins on the side sill -arrows-.
-- Push the sill panel trim onto the side sill using the :3356 .
- Vehicle resting time is at least 3.5 hours at room temperature.
Further installation is the reverse order of removal.