Overview - Bumper Cover, From Product Improvement

Fig 1: Exploded View Of Bumper Cover (From Product Improvement)

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • Quantity: 4
   • 5 Nm
2. Bolt
   • Quantity: 2
   • 2 Nm
3. End Panel
   • The bumper cover
   • Removing and Installing. Refer to BUMPER COVER END PLATE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
4. Impact Guard
   • Basic equipment version
   • Removing and Installing. Refer to IMPACT GUARD LOWER SECTION, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
5. Bolt
   • 2 Nm
6. Impact Guard
   • Equipment versions S-line
   • Removing and Installing. Refer to IMPACT GUARD LOWER SECTION, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
7. Cover
   • For the towing eye
8. Bumper Cover
   • Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
9. Air Intake Grille
   • Center
   • Removing and Installing. Refer to CENTER AIR INTAKE GRILLE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
10. Bolt
    • Quantity: 12
    • 2 Nm
11. Mount
    • for the parking aid sensor
    • Clipped in the center air intake grille
12. Radiator Grille
    • Overview. Refer to OVERVIEW - RADIATOR GRILLE .
13. Lock Carrier Cover
    • Removing and Installing. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
14. Blind Cover
    • For equipment version without parking aid sensor
    • Clipped into the mount
15. Bolt
    • Quantity: 2
    • 2 Nm
16. Mount
    • For the bumper cover side panel
    • Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
17. Securing Strip
    • For the bumper cover side panel and the side front spoiler
    • Removing and Installing. Refer to SECURING STRIP FOR BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
18. Bolt
    • Quantity: 3
    • 2 Nm
19. End Panel
    • Side
    • Removing and Installing. Refer to SIDE BUMPER COVER END PLATE, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
20. Bolt
    • 2 Nm
21. Expanding Rivet
22. Cover
    • For the headlamp washer system washer nozzle
    • Removing and Installing. Refer to HEADLAMP WASHER SYSTEM WASHER NOZZLE COVER, REMOVING AND INSTALLING .
23. Blind Cover
    • For equipment version without parking aid sensor
    • Clipped into the mount
24. Mount
    • for the parking aid sensor
    • Clipped in the side air intake grille
25. Trim
    • Only for equipment versions without Control Module for Adaptive Cruise Control -J428-
    • Clipped in the side air intake grille
26. Air Intake Grille
    • Side
    • Removing and Installing. Refer to SIDE AIR INTAKE GRILLE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
27. Bolt
    • 2 Nm
28. Front Spoiler
    • Side
    • Removing and Installing. Refer to SIDE FRONT SPOILER, REMOVING AND INSTALLING .
29. Bolt
    • 2 Nm