After-Run Coolant Pump -V51-, REMOVING AND INSTALLING, AUDI Q7/Q8: Removing
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- If installed, remove the heat shield boot.
-- Disconnect the connector -1-.
-- Place a cloth underneath to catch any escaping coolant.
-- Loosen the hose clamps -2-, then clamp off the coolant hoses with the Hose Clamps - Up To 25mm:3094 and remove them.
-- Remove the bolts -arrows- and the Recirculation Pump -V55-.
-- Remove the pump from the bracket.