Parking Lock Solenoid N486/Drive Position Sensor G676, Removing and Installing: Removing
- Remove the rear noise insulation. Refer to the appropriate Service Information.
- Remove the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Remove the bolt -arrow- and the oil pipe -1-.
- Remove the bolts -arrows- and push the coolant pipe for the transmission to the side (different versions)
- Depending on the version, remove to ensure access to the coolant pipe.
- Remove the bolts -arrows- and move the parking lock emer- gency release cable -1- to the side. (different versions)
- Press the tensioning pin -1- out using the Removal Tool -T40437- -A-.
- Depending on the transmission, the parking lock lever may be installed in various positions. See the illustrations above and below.
- Remove the bolt -2-.
- Disconnect the connector -3-.
- Remove the bolts -arrows- and the parking lock cover -1-.
- Remove the bolts -arrows-.
- At the same time using a pin punch shaft turn the parking lock approximately 3° against the spring force in direction of -arrow-.
- Remove the Parking Lock Solenoid -N486-.
- Remove the bolt -arrow- and the Drive Position Sensor - G676-.