Transmission Control Module -J217-, REMOVING AND INSTALLING: Installing

Fig 1: Transmission Control Module -J217- Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

Before installing the control module, clean the threaded holes of oil and debris.

-- Push the control module evenly on the valve body and tighten the bolts in the sequence -1 to 4- to the tightening specification.

Tip:

-- Push in the sensor arm -1- on the ATF pump -2- by hand and tighten the bolts -arrows- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of damaging the ATF pump.

- The sensor arm -1- must make contact when attaching the ATF pump -2-.

-- Tighten the bolts to the specification in the following sequence: -1 through 3-.

Fig 2: Sensor Arm Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the cover -1- for the sensor arm -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-.

Courtesy of AUDI OF AMERICA, LLC

Do not interchange the connectors.
Make sure that the connection is correct as shown -1 and 2-. Refer to Hydraulic Pressure Sensor 1 -G545- AND Hydraulic Pressure Sensor 2 -G546-, REMOVING AND INSTALLING .

-- Install the mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .

If the Transmission Control Module -J217- was replaced, the function "control module replacing" must be performed using the Vehicle Diagnostic Tester.
If the valve body is replaced, the "valve body, replacing" function must be performed using the Vehicle Diagnostic Tester.

-- Connect the Vehicle Diagnostic Tester with the vehicle.

-- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.