Right Flange Shaft, Removing And Installing: Notes
Special tools and workshop equipment required
- Circlip Pliers: VAS5503A
- Used Oil Collection and Extraction Unit: SMN372500
- Puller - Flanged Shaft: T10037
- Sealing Grease. Refer to the Parts Information.
Removing
- The transmission is installed.
-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
-- Place the Used Oil Collection and Extraction Unit: SMN372500 under the transmission.
-- Remove right flange shaft by fastening Puller - Flanged Shaft: T10037 to transmission housing -arrow-.