Transmission Output Shaft Ball Bearing, Replacing

Special tools and workshop equipment required 

• Press Plate: VW401 
• Press Plate: VW402 
• Press Piece - Rod: VW409 
• Press Piece - Multiple Use: VW412 
• Press Piece - 60mm: VW415A 
• Press Piece - Front Control Arm: 2040 

Procedure 

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the locking ring -A- on the transmission output shaft with splines and the ball bearing circlip -B-.

-- Remove the transmission output shaft from the center differential housing using the : VW409  .

-- Pry out the seal.

• To protect the housing lay for example an extractor lever -A- underneath.

-- Remove the transmission output shaft ball bearing with splines.

-- Install the transmission output shaft ball bearing with splines.

• The shoulder on the : VW415A  -arrow- faces the : VW412  .

-- Install the ball bearing circlip -B-.

• Ignore -item A-.

-- Install the transmission output shaft into the center differential housing using the : VW412  .

-- Install the locking ring -arrow- into the groove in the transmission output shaft.

-- Install the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Install the seal for the transmission output shaft with splines. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING .

-- Fill the transmission fluid and check the level. Refer to the appropriate service information. .