Bearing Bracket, Disassembling And Assembling: Notes

Special tools and workshop equipment required

Disassembling

Press Out the Shaft for the Reverse Gear Intermediate Sprocket 1

Fig 1: Press Out the Shaft for the Reverse Gear Intermediate Sprocket -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Rod: VW411

3 -

Gearbox Assembly Tool - Adapter: T40213/9

4 -

Press Plate: VW402

-- Remove the reverse gear intermediate sprocket, needle bearing and thrust washers from the bearing bracket.

Drive Out the Input Shaft Ball Bearing 1

Fig 2: Drive Out the Input Shaft Ball Bearing -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Bushing - 50mm Diameter: VW432

Reverse gear intermediate sprocket is removed. Refer to Fig 1.
Remove the bolts -item 6- OVERVIEW - BEARING BRACKET => List Item: Bolts beforehand and remove the retaining plate for the bearing -item 7- OVERVIEW - BEARING BRACKET => List Item: Retaining Plate.
Tension the bearing bracket in a vise.

Drive Out the Output Shaft Ball Bearing 1

Fig 3: Drive Out the Output Shaft Ball Bearing -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Bushing - 50mm Diameter: VW432

Remove the locking ring -item 16- OVERVIEW - BEARING BRACKET => List Item: Circlip beforehand.
Tension the bearing bracket in a vise.