E-Tron Charging System Diagnostic

Special tools and workshop equipment required 

• Diagnostic Adapter for High-Voltage Charging System: VAS611009 

Procedure 

• On the "compact" e-tron charging system the diagnosis is possible using the : VAS611009  with ODIS self-sufficient service this means without vehicle diagnostic entry.
• Because the "compact" e-tron charging system involves am external component, no VIN can be read out during diagnostic entry and consequently there are some important notes to pay attention to.
• For the diagnostic entry on the "compact" e-tron charging system pay attention to the following described steps.

-- Disconnect the High-Voltage Charging System Control Head -E943- from the power supply.

-- Disconnect the charging cable for the side of the vehicle.

-- Connect the : VAS611009  -1- between the Charging Cable for High-Voltage Charging System, Power Connection -P88- -2- and High-Voltage Charging System Control Head -E943- -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the Vehicle Diagnostic Tester to the : VAS611009  .

-- Connect the : VAS611009  to the power supply.

-- Connect the High-Voltage Charging System Control Head -E943-.

Depending on the ODIS version instead of the VIN "AUDILADEKABELMINI" is entered when entering.

-- Select ODIS Service  and start the Diagnostic  mode.

Courtesy of AUDI OF AMERICA, LLC

On the scan tool display

1. VIN not found Checking Ignition/Diagnostic Interface
2. Press the Continue  button.

On the scan tool display

Courtesy of AUDI OF AMERICA, LLC

1. An error has occurred in the automatic identification of the vehicle. Please identify the vehicle manually.
2. Press the OK  button.

-- In the "vehicle identification" line:

Courtesy of AUDI OF AMERICA, LLC

1. Activate "Manual"

-- In the "VIN" line enter the following:

2 -  "AUDILADEKABELMINI"

-- If in the "Manufacturer" line the manufacturer is not already present, select "Audi".

-- In the "Model" line enter the following:

3 -  "All External Components"

-- Ignore the lines "Model year", "Version", "Motor".

-- In the line "work with Guided Fault Finding" check:

4 -  Must be activated

-- To continue:

5 -  Press accept 

-- If possible, enter the VIN of the vehicle -arrow- with which the customer of the affected "compact" e-tron charging system is used.

Courtesy of AUDI OF AMERICA, LLC

-- Complete the test programs in the test plan.