Vibration Damper, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI

CAUTION:

Risk of destroying the engine with the friction disc not being installed.

- Check the installation of the friction disc (diamond disc) between the vibration damper and the camshaft stub.

Replace bolts that were tightened with an additional turn after removing them.

-- Place the vibration damper -1- with a friction disk (diamond disc) -2- on the crankshaft -3- and secure with a new bolt while paying attention to the alignment pin -arrow-.

-- Place the Adapter :T40330/5 with Counterholder :T40330/1 on the vibration damper and secure using the M8x35 bolt -arrow- (23 Nm) by placing the Spacer Sleeve :T40330/3 underneath.

Courtesy of AUDI

-- Tighten the vibration damper bolt -1-.

-- Remove the bolt -arrow- and remove the counterholder.

-- Install the Starter generator ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

There are different procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .