Exhaust System, Installing Without Tension

Procedure 

• Align the exhaust system when cold.

-- Loosen the front clamping sleeve -arrows-.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Push the exhaust system far enough forward in direction of -arrow- until the pretension on the retaining loop -1- at the exhaust pipe is -a- = 6 to 10 mm.

Courtesy of AUDI OF AMERICA, LLC

-- Position the front clamping sleeve and tighten the threaded connections evenly. Refer to Figure.

Tightening Specifications 

• Refer to OVERVIEW - MUFFLER