Coolant Pump, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• Used coolant cannot be used again.

-- Install the coolant pump -1- and toothed belt.

Fig 1: Identifying Controller Housing

Courtesy of AUDI OF AMERICA, LLC

-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.

Fig 2: Identifying Coolant Pump

Courtesy of AUDI OF AMERICA, LLC

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .