All-Wheel Drive Clutch Input Shaft Seal, Replacing: Installing

-- Clean the running and sealing surface.

-- Coat outer edge of the seal with ATF.

-- Fill the space between the sealing/dust lip halfway with Sealing Grease:G 052 128 A1  .

• Installed position: The open side of the seal faces the transmission housing.
• Do not tilt the seal when installing it.

-- Install the seal using the Bearing Installer - Carrier Bearing:3350  to dimension -x- .

• Dimension -x- = 11.2 mm underneath the housing lower edge

-- Install the all-wheel drive clutch. Refer to ALL-WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING 

-- Add ATF for all-wheel drive clutch and reset the >>oil age adaptation values<< in the All-Wheel Drive Control Module -J492- . Refer to ALL WHEEL DRIVE CLUTCH, REMOVING AND INSTALLING .