Overview - Bumper Cover, From Product Improvement

Fig 1: Exploded View Of Bumper Cover (From Product Improvement)

Courtesy of AUDI OF AMERICA, LLC

Impact Guard
- Removing and Installing. Refer to IMPACT GUARD, REMOVING AND INSTALLING .
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Cap
- Left: for the tail lamp bolt
- Right: for the tail lamp bolt and towing eye
Cover Strip
- Removing and Installing. Refer to COVER STRIP, REMOVING AND INSTALLING .
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
- Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Mount
- for lane change assistance control module
- Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Bolt
- Quantity: 3
- Tightening specification. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Bumper Cover Upper Section
- Removing and Installing. Refer to BUMPER COVER UPPER SECTION, REMOVING AND INSTALLING .
- Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Bolt
- Quantity: 3
- 2 Nm
Bolt
- 2 Nm
Mount
- Side
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, SIDE .
Bolt
- Quantity: 4
- Tightening sequence. Refer to Figure.
Mount
- Lower
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, BOTTOM .
Nut
- Quantity: 3
- 4 Nm
Nut
- Quantity: 4
- 4 Nm
Bolt
- Quantity: 2
- 1.5 Nm
Bolt
- Quantity: 4
- 2 Nm
Trim Molding
- Center
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
Trim Molding
- Side
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .