Molded Foam Part, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
Risk of damaging the pressure hose by deforming it.
- Never kink or stretch the pressure hose.
For Pressure Hoses without a Color Marking:
-- Measure out and mark the center of the pressure hose.
-- Position the pressure hose -1- evenly in both directions in the recess in the molded foam part -3-.
Continuation:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Engage the pedestrian protection crash sensor -2- into the molded foam part.
-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.
Connector Lock on Pedestrian Protection Crash Sensor
-- Push in the connector lock -2- to secure the connector.