Radiator Shutter, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi Q5 e and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Open the cover in direction of -arrow- and disconnect the connector -1- on the Radiator Shutter Motor -V544- and free up the wire.
-- Remove the connector -arrow- for the High Pressure Sensor -G65- from the bracket, disconnect it and free it up.
-- Release the left and right catches in direction of in direction of -arrow-.
-- Remove the radiator shutter -1- toward the front.