Front Parking Lock Emergency Release Cable, Removing and Installing, Q5: Removing
WARNING:
There is a risk of an accident from the vehicle starting to roll.
- Pull the parking brake button to activate the electro-me- chanical parking brake.
- Remove the center console. Refer to the appropriate Service Information.
- Remove the noise insulation.
- Release the retainers in direction of -A arrows- and slide the sleeve -1- on the emergency release cable in the direction of -arrow B-.
- Disengage the rear emergency release cable from the front emergency release cable in direction of -arrow C-.
- Remove the nuts -3-.
- Release the catches in direction of -arrows- and lower the bracket -2- for the emergency release.
- Remove the rear noise insulation. Refer to the appropriate Service Information.
- Equipped on some models: remove the tunnel underbody trim panel. Refer to the appropriate Service Information.
- Loosen the heat shield for the tunnel and place on the drive- shaft. Refer to the appropriate Service Information.
- Remove the bolts -arrows- and free up and remove the park- ing lock emergency release cable -1-.