Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Notes
Special tools and workshop equipment required
- Cover: T40322/1-4
- Support: T40321
- Ruler (2 pc.): T40100
Tip:
- Check before the repair, if the necessary replacement parts are available. Refer to the Parts Information.
CAUTION:
The system is under pressure.
- Deactivate the ATF pump and drain the hydraulic pressure reservoir before removal.
-- Using the Vehicle Diagnostic Tester in the Transmission Control Module -J217- empty the ATF pressure reservoir and disable the Transmission Fluid Auxiliary Hydraulic Pump -V552-. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
CAUTION:
Contamination damages the Mechatronic.
- Pay attention to absolute cleanliness when working on hydraulic control.
- Even a small amount of debris can lead to system malfunctions.
- Remove the replacement parts from their packaging just prior to installing them.
- Protect open oil channels from debris.
Electric allocation of the pressure regulating valves and solenoid valves. Refer to TRANSMISSION CONTROL .