ATF Cooler, Removing and Installing: Installing
Install in the reverse order of removal while noting the following:
NOTE:
- Replace the ATF line with seals after removing.
- Clean the ATF cooler before installing.
CAUTION:
ATF cooler leak!
- Pay attention to the ATF pipe installation position.
- The side of the pipe with three seals faces the ATF cooler.
- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence.
- If the bolts are difficult to reach, tighten them using the Torx Screwdriver Bit - T30 -VAS6959-.
- Bleed the cooling system if the drained coolant is less than or equal to 0.5 Liter, otherwise fill and bleed the cooling system. Refer to the appropriate service information.
- Check the ATF level. Refer to ATF Level, Checking .