Control Module, Removing And Installing: Removing
- All wheel drive clutch is installed.
- The ignition is off.
- Pay attention to the general repair information. Refer to REPAIR INFORMATION .
A6 TFSIe
-- Position the Engine and Gearbox Jack:VAS 6931 with the Engine/Gearbox Jack - Gearbox Support:T10337 under the tunnel brace and loosen the bolts -1- .
-- Slightly lower the rear transmission.
Continuation for All
-- Remove the bolts -arrows- and remove the driveshaft heat shield -1- (if equipped).
-- If equipped, remove the bolts -1- and remove the heat shield -2- .
-- Remove the connector -3- from the All-Wheel Drive Control Module -- -4- .
-- Unclip the cable on the all-wheel drive clutch -arrow- and move it to the side.
-- Remove the bolts -arrows- .
-- Remove the all-wheel drive Control Module -- from the all-wheel drive clutch and set it slightly at an angle and remove downward.