Dual Clutch, Removing And Installing: Installing: Notes

-- Clean the threads.

Courtesy of AUDI OF AMERICA, LLC

-- Clean the blind holes from oil.

-- Replace the input shaft seal in the clutch housing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .

-- Check if the sleeves -1 and 2- are installed.

Courtesy of AUDI OF AMERICA, LLC

-- Coat the new seals -3, 4 and 5- with ATF and install.

-- Insert the seal -6-.

• Pay attention that no dirt can fall into the transmission while cleaning.

-- Install the engaging bearing with the slave cylinder and tighten the bolts -arrows- evenly.

Courtesy of AUDI OF AMERICA, LLC

Tip:

• Depending on the version the three bolts -arrows- may not be present.

• Pay attention that the engaging bearing is installed correctly to the slave cylinder.

  Courtesy of AUDI OF AMERICA, LLC

• The bearings -arrow- are visible.

-- Install the Guide Pins - Gearbox: T40288  in the threaded hole approximately 120° offset.

Courtesy of AUDI OF AMERICA, LLC