Parking Lock, Removing And Installing: Notes

Special tools and workshop equipment required 

• Slide Hammer Set: VW771 
• Valve Guide/Clutch Release Push Rod Seal Drift: 10-206 
• Extracting Tool - Thrust Piece: T40413/15 
• Extracting Tool - Guide Sleeve: T40413/14 

Removing 

• Gear set removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
• Slide off the output gear of the drive wheel from the pinion. Refer to Fig 4.
• Vehicles with self-locking center differential: removing the roller bearing with inner output shaft. Refer to Inner Output Shaft Roller Bearing, Removing, Vehicles with Self-Locking Center Differential .
• Detach the parking lock gear. Refer to Fig 5.

Parking Lock 2, Removing

-- Remove the bolts -1-.

-- In the sleeve -1- of the parking lock -2- cut through the M10 threads.

Courtesy of AUDI OF AMERICA, LLC

-- Install the : VW771  -1- in the threads of the sleeve -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Drive out both sleeves -3- together with the parking lock -2-.

Parking Lock 3, Installing

-- Drive in the parking lock -3- in the clutch housing. At the same time drive in the sleeves -2- alternating from side to side using the : 10-206  -1- to the dimension -a-.

Dimension -a- = approximately 1.8 mm

Drive in the center sleeve -arrow- flush with the parking lock -3-.

• Pay attention to and if necessary hold the spring for the parking lock lever when driving in.

-- Tighten the bolts -1- for the parking lock -2-.