Pistons, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi Q5 e and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Arrow on the piston crown points toward belt pulley side.
-- Install the compression ring. Refer to -item ) Compression Rings.
-- Installing the oil scraping ring. Refer to -item ) Oil Scraping Ring.
-- Coat the contact surfaces on the bearing shells with oil.
-- Coat the contact surface of the bearing shells and the cylinder wall with engine oil.
-- Push the piston -1- with the : T40347 carefully by hand in the cylinder -arrow-.
- Arrow on the piston crown points toward belt pulley side.
-- Install the connecting rod bearing cap. Pay attention to the installation position -item ) Connecting Rod Bearing Cap.
-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .