Sensor Wheel, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi Q5 e and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Always replace the sensor wheel -2- each time the bolts -1- are loosened.

Fig 1: Identifying Attachment Points, Countersunk Screws, Crankshaft & Sensor Wheel

Courtesy of AUDI OF AMERICA, LLC

TIP:

After tightening a second time, the attachment point of the countersunk bolts in the sensor wheel is so deformed that the bolt heads are at the crankshaft -3- -arrows- and the sensor wheel is loose under the bolts.

Installation of sensor wheel is only possible in one position - the bores are offset.

-- If the sensor wheel is replaced perform the adaptation using the Vehicle Diagnostic Tester.