Drive Motor Temperature Sensor -G712-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi Q5 e and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the transmission. Refer to the appropriate Service Information .
-- Push the catches together in direction of -arrow A- and remove the cap -1-.
-- Remove the bolt -3- and loosen the locking tab -arrow B-.
-- Remove the panel -2- in the direction of -arrow C-.
-- Release the flat terminal -3- using the : VAS1978/7A from the connector housing -2-.
-- Loosen the wire Drive Motor Temperature Sensor -G712- from the bracket -4- -arrows-.
-- Remove the bolts -5- and remove the Drive Motor Temperature Sensor -G712- -1-.
CAUTION:
Risk of destroying the drive motor due to foreign objects.
- Cover the installation opening of the drive motor with a clean cloth.