Overview - Cylinder Block, Belt Pulley Side, Starter Generator Belt Drive
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- Ribbed Belt
- Check for wear
- Do not kink
- Belt path. Refer to Fig 2.
- Before removing, mark the running direction using chalk or a felt-tip pen.
- Removing and Installing. Refer to STARTER GENERATOR RIBBED BELT, REMOVING AND INSTALLING .
- When installing, make sure it is seated correctly on the belt pulleys
- Tensioner
- For the ribbed belt
- Removing and Installing. Refer to TENSIONER FOR RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 8 Nm +45°
- Bracket
- For the Starter Generator Coolant Pump -V621-
- installed depending on the model
- Bolt
- Starter Generator -C29-
- Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specifications. Refer to OVERVIEW - GENERATOR .
- Nut
- Tightening specifications. Refer to OVERVIEW - GENERATOR .
- Threaded Pin
- Tightening specifications. Refer to OVERVIEW - GENERATOR .
- Bracket
- for the starter generator
- Removing and Installing. Refer to STARTER GENERATOR BRACKET, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Alignment Sleeve
- Quantity: 2
- Friction Disc (Diamond Disc)
- for the connection security between the vibration damper and the crankshaft stub (cannot be delivered separately)
- Included in a delivery package OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE, STARTER GENERATOR BELT DRIVE, cannot be delivered separately
- Vibration Damper
- With alignment pin
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- Removing and Installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening Specifications
- Pre-tightening 50 Nm
- Final tightening specification 100 Nm +180°
Starter generator belt path
- Starter Generator
- Upper Tensioning Roller
- Vibration Damper
- Lower Tensioning Roller