Overview - Belt Pulley Side Sealing Flange
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- Sealing Flange, Belt Pulley Side
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Seal
- For the belt pulley side crankshaft
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Alignment Pin
- Is inserted in the belt pulley side sealing flange
- O-Ring
- Is inserted in the belt pulley side sealing flange
- Bolt
- 9 Nm
- Oil Dipstick Tube
- Alignment Pin
- Is inserted in the belt pulley side sealing flange
- O-Ring
- Replace after removing
Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
-- Tighten the bolts -1 through 10- in steps as shown:
| Step | Tightening Specifications |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |