Vibration Damper, Removing And Installing

WARNING: This page is about a different car, the 2022 Audi Q5 e and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Vehicle with High-Voltage System:

Fig 1: Coolant Pipes on Lock Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolt -arrow- to do so loosen the bumper cover end plate on the lock carrier. Refer to OVERVIEW - BUMPER COVER .

-- Push the coolant pipes to the side.

Continuation for All Vehicles:

All additional procedures are described. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

Tightening Specifications

Refer to Fig 2
Refer to OVERVIEW - BUMPER COVER .
Refer to OVERVIEW - NOISE INSULATION .

Fig 2: Coolant Pipes on Lock Carrier

Courtesy of AUDI OF AMERICA, LLC