Overview - Assembly Mount

Engine Mount

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

1. Subframe
2. Bolt
   • 20 Nm
3. Bolt
   • 10 Nm
4. Support Bearing
   • Removing and installing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
   • Installation position. Refer to Fig 2.
5. Bolt
   • 55 Nm
6. Engine Support
   • Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
7. Heat Shield
8. Bolt
   • 10 Nm
9. Bolt
   • 55 Nm
10. Engine Mount
    • With
      • Left Electrohydraulic Engine Mount Solenoid Valve -N144-
      • Right Electrohydraulic Engine Mount Solenoid Valve -N145-
    • Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING, VEHICLE WITHOUT HIGH-VOLTAGE SYSTEM .
11. Bolt
    • 90 Nm + 90°
    • Always replace after removing.
12. Bolt
    • 30 Nm

Support Bearing, Installation Position 

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

• The raised section -2- of the engine support must engage into the opening -1- on the support bearing.

Manual Transmission Mount 

Fig 3: Exploded View Of Manual Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

1. Nut
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
2. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
3. Tunnel Crossmember
   • Removing and installing. Refer to the appropriate Service Information .
4. Stop
   • For the transmission mount
5. Transmission Mount
   • Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
6. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
7. Transmission
8. Nut
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
9. Transmission Support
   • Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
10. Bolt
    • Tightening specifications. Refer to the appropriate Service Information .
11. Bolt
    • 9 Nm
12. Bracket
    • For the connector

Dual-Clutch Transmission Mount 

Fig 4: Exploded View Of Dual Clutch Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
2. Tunnel Crossmember
   • There are different versions. Refer to the Parts Information.
   • Removing and Installing. Refer to the appropriate Service Information .
3. Stop
   • For the transmission mount
4. Transmission Mount
   • Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
5. Transmission
6. Nut
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
7. Transmission Support
   • Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
8. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
9. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
10. Nut
    • Tightening specifications. Refer to the appropriate Service Information .
    • Only remove when the transmission mount must be separated from the transmission support