Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, BOLTED VERSIONS: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the screw-type clamp -2-, remove the air duct pipe from the Throttle Valve Control Module -GX3- and slightly push it to the left side.

-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the : VAS6122  .

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and remove the Charge Air Pressure Sensor -G31- from the air duct pipe.