Transmission Output Shaft Seal, Replacing

Special tools and workshop equipment required

Procedure

-- Remove the driveshaft. Refer to the appropriate service information. .

-- Pry off the dust ring -1-.

Fig 1: Identifying Dust Ring

Courtesy of AUDI OF AMERICA, LLC

Tip:

-- Remove the seal for the transmission output shaft with splines.

Fig 2: Dust Ring Cannot Be Removed Without Destroying It

Courtesy of AUDI OF AMERICA, LLC

-- Clean the running and sealing surface.

-- Coat outer edge of the seal with gear oil.

-- Mount the : T40239/1 -1- on the transmission output shaft with splines.

Fig 3: Identifying Oil Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.

-- Install the seal -2- over the guide sleeve -1- and onto the transmission output shaft.

-- Install the seal all the way using the : T40239 , -1-. Do not tilt the seal.

Fig 4: Install Shaft Seal Using T40239

Courtesy of AUDI OF AMERICA, LLC

-- Remove the : T40239/1 from the seal carefully so that the sealing lip does not fold over.

-- Install a new dust ring -1-.

Fig 5: Identifying Dust Ring

Courtesy of AUDI OF AMERICA, LLC

-- Install the driveshaft. Refer to the appropriate service information. .