Overview - Radiator Grille
- Cover
- For the front peripheral camera
- Emblem
- Overview. Refer to OVERVIEW - NAME BADGES AND EMBLEMS .
- Name Badge
- Overview. Refer to OVERVIEW - NAME BADGES AND EMBLEMS .
- Radiator Grille
- Equipped on some models: with trim molding; when installing the trim molding pay attention to the correct engagement, at the same time the radiator grille must be removed
- Removing and Installing. Refer to RADIATOR GRILLE, REMOVING AND INSTALLING .
- Mount
- For the front peripheral camera
- Removing and Installing. Refer to COMPONENT LOCATION OVERVIEW - PERIPHERAL CAMERA .
- Bolt
- Quantity: 2
- Tightening specification. Refer to COMPONENT LOCATION OVERVIEW - PERIPHERAL CAMERA .
- Reinforcement Brace
- For the radiator grille
- Removing and Installing. Refer to REINFORCEMENT BRACE, REMOVING AND INSTALLING .
- Pedestrian Protection Center Crash Sensor -G693-
- Removing and installing. Refer to PEDESTRIAN PROTECTION CENTER CRASH SENSOR -G693-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to OVERVIEW - PEDESTRIAN PROTECTION .
- Bolt
- Quantity: 15
- 2 Nm
- Bolt
- Quantity: 2
- Tightening specification. Refer to COMPONENT LOCATION OVERVIEW - PERIPHERAL CAMERA .
- Bracket
- For the front peripheral camera
- Removing and Installing. Refer to COMPONENT LOCATION OVERVIEW - PERIPHERAL CAMERA .
- Front Peripheral Camera -R243-
- Removing and Installing. Refer to COMPONENT LOCATION OVERVIEW - PERIPHERAL CAMERA .
License Plate Holder, Market-Specific Version before Product Improvement - Tightening Specification
-- Tighten the screws -1 and 3- to 1 Nm.
License Plate Holder, Market-Specific Version from Product Improvement - Tightening Specification
-- Tighten the screws -1 and 4- to 1 Nm.