Overview - Impact Member

Fig 1: Exploded View Of Impact Member

Courtesy of AUDI OF AMERICA, LLC

1. Molded Foam Part
   • Market-Specific Version
   • Removing and Installing. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
2. Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
   • Market-Specific Version
   • Unit with pressure hose
   • Observe the conditions for replacing the Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-. Refer to OVERVIEW - PEDESTRIAN PROTECTION .
   • Overview. Refer to OVERVIEW - PEDESTRIAN PROTECTION .
3. Impact Member
   • Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
4. Impact Member Mount
   • Right
   • Removing and Installing. Refer to IMPACT MEMBER MOUNT, REMOVING AND INSTALLING .
5. Bolt
   • Quantity: 2
   • Tightening specification Fig 2.
6. Impact Member Mount
   • Left
   • Removing and Installing. Refer to IMPACT MEMBER MOUNT, REMOVING AND INSTALLING .
7. Bolt
   • Tightening specification. Refer to OVERVIEW - HORN .
8. Bolt
   • Quantity: 4
   • 55 Nm
9. Bracket with Horn
   • Removing and Installing. Refer to High Tone Horn -H2- /Low Tone Horn -H7-, REMOVING AND INSTALLING .
10. Nut
    • Quantity: 2

Front Impact Member - Tightening Specification and Sequence

Fig 2: Front Impact Member - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -A- to 23 Nm in the following sequence: -1 through 4-.