Overview - Body Tail Lamps

Courtesy of AUDI OF AMERICA, LLC

1. Trim Molding
   • Removing and installing. Refer to MOLDINGS, TRIMS, EXTENSIONS AND TRIM PANELS .
2. Tail Lamp
   • Left Tail Lamp -MX3-
   • Right Tail Lamp -MX4-
   • Replace the entire tail lamp if the LED is faulty
   • Removing and installing. Refer to LOWER TAIL LAMP, REMOVING AND INSTALLING .
3. Clip Nut
4. Adjusting Nut
   • Adjusting. Refer to BODY TAIL LAMP, ALIGNING WITH BODY CONTOUR .
5. Bolt
   • Tightening specification and sequence. Refer to Fig 1.
6. Cover
   • For the tail lamp
   • Removing and installing. Refer to REAR LID TAIL LAMP, REMOVING AND INSTALLING .
7. Adjusting Nut
   • Adjusting. Refer to BODY TAIL LAMP, ALIGNING WITH BODY CONTOUR .
8. Bolt
   • Tightening specification and sequence. Refer to Fig 1.

Fig 1: Tightening specification and sequence for the tail lamps

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the screws to 3.5 Nm in the following sequence: -2 and 3-.