LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Tires And Wheel Alignment (Suspension, Wheels, Steering) >> 44 Wheels, Tires And Wheel Alignment >> Axle Alignment >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking, AUDI Q8 >> Dimension Overview

Dimension Overview

Suspension Distance Between the Center of the Wheel and the Lower Edge of the Fender/Wheel Housing
  Front Axle Rear Axle Tolerance between the right and left
Specified size. Refer to (1). Tolerance Specified size. Refer to (1). Tolerance
1BK 473 mm ± 7 mm 484 mm ± 7 mm Less than or equal to 10 mm
2MA 473 mm ± 7 mm 484 mm ± 7 mm Less than or equal to 10 mm
2MB 473 mm ± 7 mm 484 mm ± 7 mm Less than or equal to 10 mm
(1) The specified size is based on the standard vehicle height.
CAUTION:

Premature Wear Due to Incorrect Axle Alignment

- Only perform the axle alignment if the vehicle is at standard vehicle height.

scientia non olet · About LEMON Manuals