Wheel Bearing Housing, Removing And Installing: Removing
-- Loosen the connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
-- Remove the brake shield. Refer to BRAKE SHIELD, REMOVING AND INSTALLING .
-- Disconnect the connector -1- for the rear speed sensor.
-- Remove the bolt -1- and free up the bracket -2- with the wires.
-- Turn the wheel hub, until a wheel bolt hole is at the top.
Risk of Destroying the Wheel Bearing When Installing the Wheel Bolt
- Install a washer on the wheel bolt so that the wheel bolt does not press again the wheel bearing.
-- Install the : T10149 with a wheel bolt -2- and inserted washer -1- on the wheel hub.
-- Slightly lift the wheel bearing housing using the : T10149 with the : VAS6931 this allows the threaded connections to easily separate.
There Is a Risk of an Accident When Lowering the Vehicle When the Engine and Gearbox Jack Is Underneath It.
- Never lower the vehicle when the engine and gearbox jack is underneath it.
- Never leave the engine and gearbox jack under the vehicle any longer than necessary.
-- Remove the screw -2- and disconnect the threaded connection -1-.
-- Remove the bolts -3 and 4- and disconnect the connector -1-.
-- Loosen the wheel bearing housing -2- from the drive axle and remove it.