Overview - Stabilizer Bar, Without Sway Stabilization

Fig 1: Exploded View Of Stabilizer Bar, Without Sway Stabilization

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • 25 Nm + 90°
   • Always replace after removing
2. Stabilizer Bar
   • With rubber bushing and clamp
   • The rubber bushing and clamp cannot be replaced individually
   • Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITHOUT SWAY STABILIZATION .
3. Subframe
4. Nut
   • Always replace after removing
5. Front Upper Transverse Link
6. Bolt
   • 40 Nm + 180°
   • Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
   • Always replace after removing
7. Coupling Rod
   • Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
8. Bolt
   • 40 Nm + 180°
   • Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
   • Always replace after removing
9. Nut
   • Always replace after removing