Overview - Stabilizer Bar, With Sway Stabilization
- Stabilizer Bar with Sway Stabilization
- With Left Rear Suspension Stabilization Actuator -V636-
- With rubber bushing and clamp -Item ) OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION - List Item: Clamp
- The rubber bushing and clamp cannot be replaced individually
- When removing and installing, do not disconnect the wiring harness from the stabilizer bar with sway stabilization
- The connector may only be disconnected if a damaged wiring harness must be replaced.
- To ensure a proper seal, the connector on the stabilizer bar with sway stabilization may only be connected and tightened once. Tightening specification: 2 Nm
- Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, VERSIONS WITH SWAY STABILIZATION .
- Bolt
- 20 Nm
- Bracket
- For the wiring harness
- Metal Nut
- 2.5 Nm
- Heat Shield
- Bolt
- 6 Nm
- Nut
- 4 Nm
- Bracket
- For Sway Stabilization Control Module 2 -J1096-
- Subframe
- Nut
- Always replace after removing
- Sway Stabilization Control Module 2 -J1096-
- Removing and Installing. Refer to Sway Stabilization Control Module 2 -J1096-, REMOVING AND INSTALLING .
- Nut
- Always replace after removing
- Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- 40 Nm + 180°
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- Always replace after removing
- Bolt
- 40 Nm + 180°
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- Always replace after removing
- Clamp
- No replacement part
- A component of the stabilizer bar -Item ) OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION - List Item: Stabilizer Bar with Sway Stabilization
- Bolt
- 25 Nm + 90°
- Always replace after removing