SUBFRAME Rear Bonded Rubber Bushing, Replacing: Installing

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the anti-twist mechanism -1- in the area of the retaining tabs -arrows- with a screwdriver from the bonded rubber bushing alternating from side to side.

-- Pry out the plastic insert from the bonded rubber bushing.

-- Arrange the special tools as shown.

Courtesy of AUDI OF AMERICA, LLC

1. : T10205/8-1 
2. : VAS6178 
3. : T40328/3 
4. : T40328/5  : the brace must engage in the bonded rubber bushing cut-out
5. Bonded Rubber Bushing
6. : T40328/6 
7. : T10205/8-2 

-- Align the bonded rubber bushing with the markings made previously and push it in until the collar comes in contact with the bushing in the subframe without any gaps.

• If necessary, tension and press over cylinder several times.
• To prevent damage to the outer race, while pushing in, pay attention that the bonded rubber bushing is not tilted.
• The ends of the rubber bead on the bonded rubber bushing must align with the markings -arrows- on the subframe.

  Courtesy of AUDI OF AMERICA, LLC

• Correct any paint damage on subframe with corrosion protection, primer and black top coat.

-- Install the plastic insert and the anti-twist mechanism on the hydraulic bonded rubber bushing.

Further installation is the reverse order of removal.