Overview - Wheel Bearing
- Wheel Bearing Housing
- Removing and Installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
- Bolt
- 80 Nm + 90°
- Always replace after removing
- Drive Axle
- Wheel Bearing
- Wheel Bearing Unit, Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling. Refer to Removing - wheel bearing
- Wheel Hub
- The lateral run-out on the outer diameter of the wheel hub when installed can be a maximum of 0.02 mm.
- Measure the lateral run-out with the Dial Indicator - 0-10mm: VAS6079 and Dial Indicator Bracket: VAS6079/1
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Bolt
- Always replace after removing
- Before installing, clean the threads in the CV joint with a thread tap.
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .