Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING / Sway Stabilization Control Module -J924- IN VEHICLE INTERIOR ON RIGHT A-PILLAR, AUDI Q7: Removing

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the A-pillar lower right trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- De-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Disconnect the connector from the Sway Stabilization Control Module -J924-.

Courtesy of AUDI OF AMERICA, LLC

-- Press the two retaining tabs on the bracket back using a screwdriver. Remove the Sway Stabilization Control Module -J924- downward from the bracket.

Courtesy of AUDI OF AMERICA, LLC