Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING / Sway Stabilization Control Module -J924- IN RIGHT FRONT WHEEL HOUSING: Installing

Install in reverse order of removal and note the following:

-- After installing a new Sway Stabilization Control Module : J924  , activate the control module.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Suspension
• Electro-mechanical active sway stabilization
• 01 - OBD-capable systems
• D4 - Sway Stabilization Control Module J924 Front Axle
• D4 - Sway Stabilization Control Module Front Axle Functions
• D4 - Replace control module

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.