Stabilizers Control Module -J736-, REMOVING AND INSTALLING, AUDI Q8: Installing

Install in reverse order of removal and note the following:

-- After installing a new Stabilizers Control Module -J736-, activate the control module.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Diagnostic-Capable Systems
• 00D4 - Stabilizers Control Module J736, front axle
• 00D4 - front axle Sway Stabilization Control Module, functions
• 00D4 - Replace control module

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.