Stabilizer Bar, Removing And Installing, With Sway Stabilization: Installing

Install in reverse order of removal and note the following:

-- Re-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Put the system into operation after installing a new stabilizer bar with sway stabilization.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Suspension
• Electro-mechanical active sway stabilization
• 01 - OBD-capable systems
• D4 - Sway Stabilization Control Module J924 Front Axle
• D4 - Sway Stabilization Control Module Front Axle Functions
• D4 - basic setting
• D4 - Operation

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.