Overview - Stabilizer Bar, Without Sway Stabilization

Fig 1: Exploded View Of Stabilizer Bar, Without Sway Stabilization

Courtesy of AUDI OF AMERICA, LLC

1. Nut
   • 50 Nm
   • Always replace after removing
   • Remove and tighten evenly alternating from side to side.
2. Clamp
3. Stabilizer Bar
   • With rubber bushing
   • The rubber bushing cannot be replaced separately
   • Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITHOUT SWAY STABILIZATION .
4. Nut
   • 40 Nm + 90°
   • Always replace after removing
5. Subframe
6. Bolt
   • Always replace after removing
7. Coupling Rod
   • Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
8. Shock Absorber Fork
   • Removing and Installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
9. Nut
   • 40 Nm + 90°
   • Always replace after removing
10. Bolt
    • Always replace after removing