OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION /Sway Stabilization Control Module -J924- IN RIGHT FRONT WHEEL HOUSING

Fig 1: Exploded View Of Stabilizer Bar, With Sway Stabilization /Sway Stabilization Control Module -J924- In Right Front Wheel Housing

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 55 Nm
- Always replace after removing
- Remove and tighten evenly alternating from side to side.
Clamp
Bolt
- 9 Nm
Nut
- 9 Nm
Stabilizer Bar with Sway Stabilization
- With Left Front Suspension Stabilization Actuator -V634-
- With Right Front Suspension Stabilization Actuator -V635-
- With rubber bushing
- The rubber bushing cannot be replaced separately
- When removing and installing the stabilizer bar with sway stabilization the wiring harness may not be removed from the stabilizer bar with sway stabilization. The connector may not be removed.
- Stabilizer bar with sway stabilization, removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITH SWAY STABILIZATION .
Nut
- 60 Nm +90°
- Always replace after removing
Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
Shock Absorber Fork
- Removing and Installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
Nut
- 60 Nm +90°
- Always replace after removing
Bolt
- Always replace after removing
Sway Stabilization Control Module -J924-
- Removing and Installing. Refer to Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING .
- Component location. Refer to the appropriate Wiring Diagram.
- Component location on vehicles without a connector in the wiring harness in the right front wheel housing on the top of the A-pillar
- Component location on vehicles with connector in the wiring harness in the vehicle interior on the center right A-pillar
Clip
Bracket
- For Sway Stabilization Control Module -J924-
Bolt
- 7 Nm
Bolt
- 9 Nm
Reinforcement
Bolt
- 9 Nm
Subframe
Nut
- 9 Nm
Bracket
- For the wiring harness
Bracket
- For the wiring harness