Control Arm Ball Bearing, Replacing, Wheel Bearing Housing Side

Special tools and workshop equipment required 

• Press Plate: VW402 
• Press Piece - Multiple Use: VW412 
• Press Piece - 42mm: VW516 
• Press Piece - Reverse Gear Syncro: 3296 
• Assembly Paste: G 052 109 A2 

Procedure 

• The control arm is removed. Refer to CONTROL ARM, REMOVING AND INSTALLING .

Bonded Rubber Bushing, Pressing Out 

-- Mark the press-in depth of the bonded rubber bushing -1- for example using a waterproof felt-tip pen -arrow-.

-- Arrange the special tools as shown.

• Hold the control arm firmly in position while pressing the bonded rubber bushing out and in.

-- Press out the bonded rubber bushing from the control arm -2-.

Bonded Rubber Bushing, Pressing In 

-- Transfer the press-in depth mark from the old bonded rubber bushing to the new one.

-- Thinly coat the bonded rubber bushing with Assembly Paste: G 052 109 A2  .

-- Insert the bonded rubber bushing -1- in the control arm -2-.

-- Arrange the special tools as shown.

-- Press the bonded rubber bushing in the control arm, and do not tilt it.

-- Pay attention to the mark -arrow- for the press-in depth.

-- Check the press-in depth of the bonded rubber bushing -1- in the control arm -2-.

• Specified value: dimension -a- = dimension -b-.

-- If the values are different, press in the bonded rubber bushing again.